[互助]联合仿真lna 出现如下问题

[upload=1]  [upload=1] Simulation / Synthesis Messages cj)~7 WF  
Warning detected by hpeesofsim during TRAN analysis `SP1'. M"V@>E\L  
    COMPONENT `X4_LNA_schematic_13_1': -Zh+5;8g  
       Simulator uses frequency lower than frequency range of Momentum model. The S-parameters are extrapolated. q\<vCKI-^  
Warning detected by hpeesofsim during TRAN analysis `SP1'. suwj1qYJ4  
    COMPONENT `X4_LNA_schematic_13_1': IA'AA|v  
       The model for the Layout Component is not found in the ModelDatabase, a new model is generated for the requested parameter values. &gfQZxT  
Warning detected by hpeesofsim during TRAN analysis `SP1'. WMg^W(  
    COMPONENT `X4_LNA_schematic_13_1': ~ln,Cm} 4  
       The model for the Layout Component is reused from the ModelDatabase. 1GxYuTZ{  
Warning detected by hpeesofsim during SP analysis `SP1'. ;.Y`T/eWS  
    The simulation temperature (25.0 C) is not the same as the IEEE standard ~qF9*{~!  
    noise temperature (290 K or 16.85 C) in the noise analysis `SP1'. `,O^=HBM  
    If the simulation temperature is not equal to the IEEE standard temperature, gg9W7%t/  
    then the loss and the noise figure will not agree for a passive circuit. AJ /_l;  
    The `Temp' parameter on the Options item can be set to 16.85 C to EUgs2Fsb3  
    eliminate this warning message. VTdZ&%@  
.. Z8W<RiR  
V RL6F2 >6  

未注册仅能浏览部分内容，查看全部内容及附件请先 登录 或 注册

你确定线都连好了?

我最近仿真也总是出现 这个The model for the Layout Component is not found in the ModelDatabase, a new model is generated for the requested parameter values不知道什么原因啊，坐等高手解答

我也出现问样问题了，望解答