[互助]联合仿真lna 出现如下问题

[upload=1]  [upload=1] Simulation / Synthesis Messages V1ug.Jv^  
Warning detected by hpeesofsim during TRAN analysis `SP1'. 4AGc2e'u  
    COMPONENT `X4_LNA_schematic_13_1': 2dC)%]aLme  
       Simulator uses frequency lower than frequency range of Momentum model. The S-parameters are extrapolated.  *q^'%'  
Warning detected by hpeesofsim during TRAN analysis `SP1'. :!%oQQO  
    COMPONENT `X4_LNA_schematic_13_1': eu#||  
       The model for the Layout Component is not found in the ModelDatabase, a new model is generated for the requested parameter values. }Eav@3h6  
Warning detected by hpeesofsim during TRAN analysis `SP1'. vjHbg#0%  
    COMPONENT `X4_LNA_schematic_13_1': &rn,[w_F[  
       The model for the Layout Component is reused from the ModelDatabase. 4ngiad6bR  
Warning detected by hpeesofsim during SP analysis `SP1'. !n7?w@2a'  
    The simulation temperature (25.0 C) is not the same as the IEEE standard 5+U~ZW0|+  
    noise temperature (290 K or 16.85 C) in the noise analysis `SP1'. 3yTBkFI!  
    If the simulation temperature is not equal to the IEEE standard temperature, /fX]Yu  
    then the loss and the noise figure will not agree for a passive circuit. k=LY 6  
    The `Temp' parameter on the Options item can be set to 16.85 C to U}UIbJD*=  
    eliminate this warning message. ?f%@8%px  
.. |PWLFiT(>  
2uB.0  

未注册仅能浏览部分内容，查看全部内容及附件请先 登录 或 注册

你确定线都连好了?

我最近仿真也总是出现 这个The model for the Layout Component is not found in the ModelDatabase, a new model is generated for the requested parameter values不知道什么原因啊，坐等高手解答

我也出现问样问题了，望解答