[数据处理]CST MWS频域1D结果的归一化问题

归一化是以各个频点各自对应的值归一化的~

参考资料：《Discrete Port》 E`C
!q X>  
摘抄如下： PY3bn).uR  
Monitor voltage and current: If this option is activated, the voltage across and the current through the discrete port are monitored during the simulation. The resulting time and frequency domain curves are placed in the navigation tree folder 1D Results Discrete Ports Voltages and 1D Results Discrete Ports Currents, respectively. j
ffNA^e  

~v:IgS  
Please note that the spectral amplitude results represent peak values and are normalized to the spectrum of the defined reference signal. In case of the S-parameter discrete port type, all results refer to an input power of 1 W. 7[K3kUm[  
6V@_?a-K  
可见电压和电流的谱幅度是对参考信号归一化过的，因此激励幅度变化后，此结果不变。 VeY&pPQ  
K_:2sDCaN  
要得到楼主的结果，还是要使用后处理模板！自行使用傅立叶变换进行处理，从而得到需要的结果~

引用第11楼zhknpu于2012-05-07 12:16发表的 回 8楼(acmilan) 的帖子 : LpSF*xm  
参考资料：《Discrete Port》 0
=t2|,}  
摘抄如下： }~ N\A  
Monitor voltage and current:If this option is activated, the voltage across and the current through the discrete port are monitored during the simulation. The resulting time and frequency domain curves are placed in the navigation tree folder 1D Results Discrete Ports Voltages and 1D Results Discrete Ports Currents, respectively.
Please note that the spectral amplitude results represent peak values and are normalized to the spectrum of the defined reference signal. In case of the S-parameter discrete port type, all results refer to an input power of 1 W. Li0+%ijM  
....... l{ql'm  

?TIi0;h  
这个帮助文件里面说的和楼主要仿真的东西不是一个，而且这里的归一化应该是只S参数，而不是只电压和电流 _*8 6  
'irwecd8  
楼主是平面波激励，看端口上接收到的信号，这个不是归一化的

请仔细看楼主在8楼贴出的图，给出的是离散端口的电压、电流的波形。我这个是回复楼主在8楼的问题，与原始问题无关。

楼主还是上CST文件吧，我估计我们俩有个人理解错了，或者我们俩都没明白。。

谢谢楼上二位的热心帮助！！ yuJ>xsM  
我做的响应幅度确实是不变的，和9楼上的图不一样。。。 1x\k:2U  
晚上回去上CST文件，请各位不吝指教，一起讨论

上CST文件 ElDeXLr'  
第一个文件为原始激励幅度，后缀AMP TO 10的为将激励幅度变小为10的

你就要仿真3.6MHz频点？

是要宽频带响应

9L的结果是怎么出来的。。。？为什么我的是幅度不变的