[求助]XFDTD中的Wire和Port设置问题

XFDTD中的Wire和Port具体作用是什么，设置的依据是什么。比如我要仿真一个周期性金属网格的电磁波透过率，该如何 .. s;0eD5b>x  

%ycCNS  

未注册仅能浏览部分内容，查看全部内容及附件请先 登录 或 注册

周期性金属网格仿真，最好考虑线金属模型的FDTD，不知XFDTD有这个功能没有？

请教一下什么是线金属模型的FDTD，有参考资料吗？谢谢

关于wire模型，就是一种理想导体金属线，XFDTD可以设置不同粗细的wire—— pn $50c  
出处：XFDTD 6.3 ReferenceManual.pdf 6$6NVq  
Thin Wires omjLQp[%  
Thin wire materials may be used in special situations where a wire with a radius much 1UM]$$:i  
smaller than the cell size is required.  In most cases, material #1 (PEC), will serve well mTP.W#N
 
as a wire.  However, in cases where the wire radius is important to the calculation and is ~v54$#CB  
less than approximately 1/5 the cell size, the thin wire material may be used to fA,+qs  
accurately simulate the correct wire dimensions.   Y!7P>?)`,X  
Thin wire materials are subject to several restrictions due to the special modifications 78QFaN$  
they require on the field update equations. Thin wires may not meet at 90 degree angles a+~o: 5  
and they may not be located on adjacent cell edges. There must be a minimum of one |(P;2q4>  
non-thin wire cell between any two adjacent thin wire cells.   Attaching thin wire materials Lv^j l  
end-to-end is the desired method of using this material type.   |%V.Lae  
If a feed or port will be connected to a thin wire, the cell edge at the feed should also be I(<G;ft<}  
thin wire material, not free space.  For example, if a dipole antenna is simulated in thin qBNiuV;*  
wire material, the feed "gap" should also be thin wire. Failing to use thin wire material in ai`:HhE  
the feed gap will lead to incorrect impedance and gain results. If you do add a feed or \34|9#*z-  
port to thin wire materials, you may not specify inductance or capacitance values to that yX~[yH+Pn  
port because these will interfere with the thin wire calculation.  However, resistor values I@S<D"af  
(series or parallel) may be used. CXQ
?P  
Fp]8f&l8  
关于wire上的port设置，一定要直接在金属wire上的网格直接设置port

十分感谢楼上版主的指导。请教一下，Port的作用是什么，仿真电磁场的传播为什么要设置它？