[求助]XFDTD中的Wire和Port设置问题

XFDTD中的Wire和Port具体作用是什么，设置的依据是什么。比如我要仿真一个周期性金属网格的电磁波透过率，该如何 .. ~oW8GQ  
B]KLn?zt5  

未注册仅能浏览部分内容，查看全部内容及附件请先 登录 或 注册

周期性金属网格仿真，最好考虑线金属模型的FDTD，不知XFDTD有这个功能没有？

请教一下什么是线金属模型的FDTD，有参考资料吗？谢谢

关于wire模型，就是一种理想导体金属线，XFDTD可以设置不同粗细的wire—— R_&z2I  
出处：XFDTD 6.3 ReferenceManual.pdf |?=1tS{iT  
Thin Wires "Oko|3  
Thin wire materials may be used in special situations where a wire with a radius much 'oL[rO~j  
smaller than the cell size is required.  In most cases, material #1 (PEC), will serve well E8<i PTJs  
as a wire.  However, in cases where the wire radius is important to the calculation and is Bcon4  
less than approximately 1/5 the cell size, the thin wire material may be used to *{s
[$}uQ  
accurately simulate the correct wire dimensions.   mXaUWgO  
Thin wire materials are subject to several restrictions due to the special modifications 97dI4t<  
they require on the field update equations. Thin wires may not meet at 90 degree angles <!>}t a  
and they may not be located on adjacent cell edges. There must be a minimum of one I|;#VejX  
non-thin wire cell between any two adjacent thin wire cells.   Attaching thin wire materials !|c5@0Wr  
end-to-end is the desired method of using this material type.   bQjHQ"
G  
If a feed or port will be connected to a thin wire, the cell edge at the feed should also be Hv*O9!cC  
thin wire material, not free space.  For example, if a dipole antenna is simulated in thin DP]|}8~L  
wire material, the feed "gap" should also be thin wire. Failing to use thin wire material in (Fd4Gw<sq  
the feed gap will lead to incorrect impedance and gain results. If you do add a feed or MA6%g} o  
port to thin wire materials, you may not specify inductance or capacitance values to that GTNTx5H  
port because these will interfere with the thin wire calculation.  However, resistor values +0 |0X {v  
(series or parallel) may be used. #7ZBbq3=  
C8q-gP[  
关于wire上的port设置，一定要直接在金属wire上的网格直接设置port

十分感谢楼上版主的指导。请教一下，Port的作用是什么，仿真电磁场的传播为什么要设置它？